A sump pump check valve is one of the most important parts of a basement sump pump system. It keeps water from entering back into the discharge pipe when the sump pump isn’t running.
You can install a new sump pump check valve yourself, or hire a professional to do it for you. Answer a few questions in our free quote wizard and get matched with top-rated pros near you!
Cost
A sump pump check valve is a device that keeps water from flowing back into the discharge pipe whenever the motor has completed pumping. This saves money on electrical costs and prolongs the life of your sump pump’s motor.
Installing a check valve is a relatively simple job, but it requires knowledge of the plumbing system. Make sure you have the proper tools to do the job right.
The price for a check valve can vary, depending on the model you buy. You can get a double-check valve for around $135, and you can get one with a single check valve for about $100.
If you have a leaking, broken, or loud valve, it’s time to replace it. A new valve should cost about $15 to $30, but it might be more expensive if you need a new float switch.
Installation
A sump pump check valve is an important part of a home’s drainage system. It prevents water from reentering the pipe whenever your sump pump isn’t running.
To install a new sump pump check valve, you will need a few tools and supplies. The first step is to buy the correct size valve for your drain pipe. You can find these at hardware stores and online.
Next, you’ll need a hacksaw or pipe cutter to sever the end of the piping where you plan to place your check valve. Measure the length between each set of couplings or hose clamps to determine how much piping you will need to cut.
Once you have the right amount of piping, cut it to the length of your valve and test-fit everything before making any adjustments. Be sure to sand down each section of the piping until it fits smoothly.
Maintenance
A sump pump is an important part of your home’s plumbing system. It keeps water out of your basement and protects its contents from flooding.
However, like any mechanical device, a sump pump can break down and need repair or replacement. Having an experienced technician conduct routine inspections and maintenance will ensure that your system is working at peak performance.
Installing a check valve is a simple and effective way to reduce your electrical bills and prolong the life of your sump pump motor. It prevents water from flowing back into the discharge piping when the pump is not running.
To install a check valve, start by measuring the length of your existing pipe. Then, use a hacksaw or a pipe cutter to snip off the section you need. Next, connect your new check valve to the end of the shortened section using PVC couplings and nuts. If your valve comes with rubber o-rings, slide those into place as well.
Repair
A check valve is an important part of a sump pump system. It keeps water in the discharge pipe from flowing back into your sump pit when the pump switches off.
A faulty sump pump check valve can cause your system to overheat and shorten its lifespan, so it’s worth replacing it. This can save you a lot of money in energy costs and prevent the pump from overheating on a regular basis.
It also prevents debris from blocking the flow of water through the check valve. If this isn’t corrected, it can cause your system to fail and flood your basement.
The check valve is usually installed vertically in the discharge pipe that rises out of your sump pump. It’s positioned close to the ground level to help the entire system run smoothly and efficiently.
There are many types of check valves available, and it’s best to choose one that is right for your system. For example, a spring-loaded clear check valve makes it easy to see if your pumping system is working properly.
